Przejdź do treści

Instrukcje

Aeotec

LED Bulb 6 Multi-White

Connecting LED Bulb to an Existing Network.

Getting your LED Bulb up and running is as simple as inserting it into a lamp holder and adding it to your existing Z-Wave network. You’ll need to set your Z-Wave hub to accept new products; to do this, please refer to its user manual.

  1. Toggle off the wall switch into the OFF position.
  2. Remove any existing light bulb and replace it with LED Bulb.
  3. Set your Z-Wave gateway to accept or pair new products.
  4. With LED Bulb in its fitting, toggle your wall switch ON. LED Bulb’s LED will blink 2x times to indicate that it is looking for a Z-Wave network to connect to.
  5. After successfully connecting to your network, LED Bulb will blink off then on in about half a second to indicate that it attempted to pair to your network. If a network connection has failed, LED Bulb 6 Multi-White will not react.

Removing LED Bulb from a Z-Wave network.

Your LED Bulb can be removed from your Z-Wave network at any time using your Z-Wave gateway. To set your gateway into removal mode, please refer to the respective section of its user manual.

  1. Set your Z-Wave gateway into device removal mode.
  2. Turn LED Bulb’s wall switch on and wait 1 second.
  3. Toggle LED Bulb’s wall switch off -> on, off -> on, off -> on (between 0.5 - 2 seconds per re-power).
  4. LED Bulb 6 if successful will flash once, dim to 5% for 5 seconds, then increase to 100% dim level to indicate a successful unpair and factory reset.

Removing LED Bulb from your Z-Wave network will reset LED Bulb to default factory settings.